Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
Figure 9
5 Use this screen to change the IP address, subnet mask, and default gateway
IP address for your network. Apply the settings. If you change the MSAP2000
AAMS's IP address, you must use the new IP address if you want to access
the web configurator again.
Figure 10
6 Skip to step
default for all of the ADSL ports). Otherwise, use the following steps to
change the VPI and VCI settings for all of the ADSL ports.
First you will delete the default virtual channel from all of the ADSL ports
(you cannot edit it).
Adding another virtual channel without deleting the default virtual channel is
not recommended since you cannot set the new channel to be the port's
super channel. The super channel can forward frames belonging to multiple
VLAN groups (that are not assigned to other channels). A channel that is
not the super channel can only forward frames with a single VLAN ID (that
is configured on that channel). The MSAP2000 AAMS would drop any
frames received from the subscriber that are tagged with another VLAN ID.
Then you will configure a new virtual channel for a port and copy it to the other
ADSL ports
7 Under Basic Setting, click xDSL Port Setup.
Basic Setting IP Setup Menu
IP setup
15
if you have your subscribers use VPI 0 and VCI 33 (the
35
Advertisement
Table of Contents
