Table of Contents
Advertisement
LED test
In this screen, you can check that the four LEDs are functioning properly.
Database statistics
For service purposes, the database statistics are displayed in the screen form.
6.6.6
Sprachauswahl/Language selection
The operator panel downloads the texts for the different languages from the drive.
You can change the language of the operator panel via the "Sprachauswahl/Language
selection" menu.
Note
Additional languages for the display
Languages in addition to the current available languages in the display are available on
request.
6.6.7
Operation via the operator panel (LOCAL mode)
You activate the control keys by switching to LOCAL mode. If the green LED in the
LOCAL/REMOTE key does not light up, the key is not active.
Note
OFF in REMOTE
If the "OFF in REMOTE" function is activated, the LED in the LOCAL-REMOTE key flashes.
For LOCAL master control, all of the supplementary setpoints are deactivated.
After the master control has been transferred to the operator panel, the BICO interconnec-
tions at bit 0 to bit 10 of the control word of the sequence control are not effective (refer to
function diagram 2501).
Note
Message "Other device has master control"
If STARTER has master control, then when pressing the LOCAL-REMOTE button, the
"Other device has master control" message is displayed, and the master control transfer is
rejected.
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
6.6 Control via the operator panel
Operation
309
Advertisement
Table of Contents
