Siemens SINAMICS S150 NEMA Operating Instructions Manual page 385

PROFIenergy control commands
Control command
START_Pause
START_Pause_with_time_response Switches from the operating state to the energy-saving mode
END_Pause
PROFIenergy query commands
Query command
List_Energy_Saving_Modes
Get_Mode
PEM_Status
PEM_Status_with_CTTO
PE_Identify
Query_Version
Get_Measurement_List
Get_Measurement_List_with_object
_number
Get_Measurement_Values
Get_Measurement_Values_with_
object_number
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
6.9 Communication via PROFINET IO
Description
Switches from the operating state to the energy-saving mode
depending on the pause duration.
Switches from the energy-saving mode to the operating state
depending on the pause duration.
and also specifies the transition times in the command
response.
Switches from the energy-saving mode to the operating state.
Cancels a switch from the operating state to the energy-saving
mode.
Description
Determines all supported energy-saving modes.
Determines the energy-saving mode.
Determines the current PROFIenergy status.
Determines the actual PROFIenergy status, the same as for
the command "PEM status" and in addition with the regular
transition time to the operating state.
Determines the supported PROFIenergy commands.
Shows the implemented PROFIenergy profile.
This command returns the measured value IDs that can be
accessed using the "Get_Measurement_Values" command.
This command returns the measured value IDs and the
associated object number that can be accessed using the
"Get_Measurement_Values_with_object_number" command.
The command returns the requested measured value using the
measured value ID:
For power measured values:
•
The command addresses the sum of the measured value over
all control drive objects.
For energy measured values:
•
The command returns the sum of the measured value over all
control drive objects.
For power factors:
•
This measured value is supported only for a SINAMICS with a
control drive object.
This command returns the requested measured values using
the measured value ID and the object number. The object
number corresponds to the drive object ID.
The drive object ID of the Control Unit is used to address the
measured values as with "Get_Measurement_Value".
Operation
383