Table of Contents
Advertisement
Commissioning
5.5 Initial commissioning with the AOP30
NOTICE
Material damage when selecting the incorrect encoder supply voltage
Once the encoder has been commissioned, the supply voltage (5/24 V) set for the encoder
is activated on the SMC30 module. The encoder may be damaged, if a 5 V encoder is
connected and the supply voltage has not been set correctly (bit 20 = "Yes," bit 21 = "No").
• Set the correct supply voltage for the connected encoder.
Basic commissioning: Entering the basic parameters
256
Entering the basic commissioning
parameters:
p0700: Preset command source
5: PROFIdrive
6: TM31 terminals
7: Namur
10: PROFIdrive Namur
p1000: Preset setpoint source
1: PROFIdrive
2: TM31 terminals
3: Motorized potentiometer
4: Fixed setpoint
Once a setpoint source has been selected
(p1000), the main setpoint p1070 is
defaulted accordingly.
To navigate through the selection fields,
choose <F2> or <F3>.
To activate a selection, choose <F5>.
To change a parameter value, navigate to
the required selection field and activate
with <F5>.
Another window appears in which you can
- enter the required value directly, or
- select the value from a list.
Operating Instructions, 12/2018, A5E36652151A
Enclosed Drives
Advertisement
Table of Contents
