Table of Contents
Advertisement
DC fuses
Frame size HX, replacement, 780
Frame size JX, replacement, 783
DCC, 30, 437
DCP flashing, 372
DDS (drive data set), 271
Copy, 274
Decrease Key, 311
Derating behavior at increased pulse frequency, 547
Derating data, 799
Current derating as a function of the pulse
frequency, 801
Decreasing the ambient temperature and the output
current, 800
Installation altitudes over 6,600 ft and up to
16,500 ft (2000 m to 5000 m) above MSL, 800
Permissible output current as a function of the
ambient temperature, 799
Using an isolation transformer, 801
Determining drive object numbers, 335
Determinism, 367
Diagnostics, 718
LEDs, 718
Parameter, 728
Diagnostics channels, 341
Digital inputs, 108, 109
Digital inputs/outputs, 90, 92, 113, 189, 191
Digital outputs, 496
Direction of motor rotation, 73
Direction reversal, 441, 553
Disconnect the basic interference suppression
module, 77
Disposal, 827
Downloading the firmware (operator panel), 795
Drive Control Chart, 437
Drive Control Chart (DCC), 30
Drive data set, 271
Drive objects, 268, 268
DRIVE-CLiQ interface, 89, 188
Droop Function, 477
dv/dt filter plus Voltage Peak Limiter (option L10), 120
E
Edge evaluation of the zero mark, 592
EDS (encoder data set), 272
Efficiency optimization, 513
Method 1, 514
Method 2, 515
EIP, 401
Electrical installation
Checklist, 56
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
Electromagnetic compatibility
EMC-compliant design, 65
Introduction, 63
Noise emissions, 64
Operational reliability and noise immunity, 63
Electromagnetic fields, 22
Electrostatic sensitive devices, 25
EMERGENCY OFF category 0 (option N57), 128
EMERGENCY STOP category 1 (option N59), 130
EMERGENCY STOP category 1 (option N60), 131
Encoder data set, 272
Encoder evaluation, 588
Encoder range, 603
Encoder track monitoring, 589
Encoder with gear factor, 260
Energy-saving display, 560
EPOS
Flying referencing using Safety Integrated
Functions, 677
Safe referencing, 675
Error values in parameter responses, 332
Essential service mode, 574, 574
Ethernet interface, 151, 241
EtherNet/IP, 401
Activating X1400 (CBE20), 403
Activating X150 CU320-2 PN, 403
Commissioning the drive, 402
Connect the drive device, 402
Create generic I/O module, 401
Integrating the drive into an Ethernet network, 414
Make the communication settings, 403
Extended brake control, 621
Extended monitoring functions, 626
External alarm 1, 734
External fault 1, 734
External fault 2, 735
External fault 3, 735
External supply, 84
F
F7860 – External fault 1, 734
F7861 – External fault 2, 735
F7862 – External fault 3, 735
Factory setting, 261
Fan
Active Interface Module (frame size FI)
replacement, 772
Active Interface Module (frame size GI)
replacement, 774
Active Interface Module (frame size HI)
replacement, 776
Index
851
Advertisement
Table of Contents
