Siemens SINAMICS S150 NEMA Operating Instructions Manual page 336

Operation
6.7 Communication according to PROFIdrive
Error Meaning
value
0x7A Parameter %s [%s]: Write access
only in the commissioning state, data
record base configuration
(device: p0009 = 4).
0x7B Parameter %s [%s]: Write access
only in the commissioning state,
device configuration
(device: p0009 = 1).
0x7C Parameter %s [%s]: Write access
only in the commissioning state,
device download
(device: p0009 = 29).
0x7D Parameter %s [%s]: Write access
only in the commissioning state,
device parameter reset
(device: p0009 = 30).
0x7E Parameter %s [%s]: Write access
only in the commissioning state,
device ready (device: p0009 = 0).
0x7F Parameter %s [%s]: Write access
only in the commissioning state,
device (device: p0009 not equal to 0).
0x81 Parameter %s [%s] must not be
written during download.
0x82 Transfer of master control is blocked
by BI: p0806.
0x83 Parameter %s [%s]: Requested BICO
interconnection not possible.
0x84 Parameter %s [%s]: Parameter
change inhibited
(refer to p0300, p0400, p0922)
0x85 Parameter %s [%s]: Access method
not defined.
0x87 Write job will not be executed.
0xC8 Below currently valid limit.
0xC9 Above currently valid limit.
0xCC Write access not permitted.
334
Comment
–
–
–
–
–
–
–
–
BICO output does not supply float values, however the
BICO input requires float values.
–
–
The write job is rejected because know-how protection is
active.
Modification request for a value that, although within
"absolute" limits, is below the currently valid lower limit.
Modification request for a value that, although within
"absolute" limits, is above the currently valid upper limit
(e.g., specified by the actual converter rating).
Write access is not permitted because an access code is
not available.
Operating Instructions, 12/2018, A5E36652151A
Additional
info
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
Enclosed Drives