Table of Contents
Advertisement
Normalization for object A_INF
Table 6- 8
Normalization for object A_INF
Variable
Reference frequency
Reference voltage
Reference current
Reference power
Reference modulation depth
Reference temperature
TM31 object
Table 6- 9
List of signals for the operation screen – TM31 object
Signal
Analog input 0 [V, mA]
Analog input 1 [V, mA]
Analog input 0, scaled
Analog input 1, scaled
Curve recorder settings
In this menu, the following settings can be made:
Parameter selection
You can select here the parameter whose signal is to be displayed in the form of a trend
curve in the curve recorder.
Interpolation (factory setting: No), serves for the better display of rapidly changing quantities.
● No: Only the measured values are displayed as points, without a connecting line between
the points.
● 1: The measured values are connected with a vertical line.
● 2: The measured values are connected with a line, offset at the center.
Time base (factory setting: 2 minutes/screen)
The rate of the signal acquisition in minutes per screen is set. The value can be changed in
integer multiples of 2. If an odd value is entered, the value will be rounded up. After changing
the time basis the recording is started again.
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
Scaling parameter
100% = p2000
100% = p2001
100% = p2002
100% = r2004
100% = Maximum output voltage without overload
100% = p2006
Parameter
r4052[0]
r4052[1]
r4055[0]
r4055[1]
6.6 Control via the operator panel
Short name
Unit
AI_UI
V, mA
AI_UI
V, mA
AI_%
%
AI_%
%
Operation
Default for quick commis-
sioning
p2000 = p0211
p2001 = r0206/r0207
p2002 = r0207
r2004 = r0206
p2006 = 100°C
Scaling
(100% = ...)
V: 100 V / mA: 100 mA
V: 100 V / mA: 100 mA
as set in p200x
as set in p200x
303
Advertisement
Table of Contents
