Gear Box Assembly
g251083
1.
Screw (2 each)
2.
Groomer drive box assembly
3.
Cotter pin
Removing the Gear Box Assembly
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
4.
Clevis pin
5.
Screw
6.
Seal shield
Note: The groomer gear box assembly is located on the right side of the cutting
unit.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
2. Remove the groomer reel assembly; refer to
(page
9–12).
Contact with the reel or other cutting unit parts can result in personal
injury.
Use heavy gloves when handling the cutting unit.
3. Safely prevent the reel from rotating by blocking the cutting unit with a piece
of wood near one of the reel spiders.
The groomer gear box use a right-hand thread. Turn the input shaft
counterclockwise to remove the gear box.
Figure 217
CAUTION
IMPORTANT
Page 9–5
Universal Groomer (Optional): Service and Repairs
7.
Input shaft
8.
Greens weight
Removing the Groomer Reel