Toro Greensmaster eFlex 1800 Service Manual page 89

Assembling the Reel Clutch Shaft (continued)
Installing the Reel Clutch Shaft
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
When installing the flex coupler (item 10 in
do not damage the outer surface of the coupler (e.g., grasping with
pliers or mounting in vise) as coupler may be damaged and fail
prematurely.
11. Slide the flex coupler onto the bearing collar (item 15 in
the coupler to prevent it from being damaged during the spring pin installation.
Install a new spring pin into the coupler to secure the coupler to the collar.
1. Before inserting the reel clutch assembly into the transmission housing, clean
the reel brake ring (item 2 in
2. Slide the reel clutch shaft assembly into the transmission housing.
3. Align the missing tooth in spline area of the reel clutch lever (item 27 in
48) with the reel clutch fork. Insert the lever through the housing and fork.
Secure the lever with the retaining ring.
4. Install the transmission drive belt and all the machine components removed
for the reel drive system service; refer to
4–38).
5. Check the reel clutch adjustment; refer to
4–12). Adjust as necessary.
6. Connect the reel clutch cable to the transmission; refer to
Clutch Cable (page
7. Connect the battery pack; refer to
(page 4–3).
IMPORTANT
Figure 48) that is pressed into the housing.
Transmission Drive Belt (page
Adjusting the Reel Clutch (page
6–10). Ensure that the clutch cable is properly adjusted.
Connecting the Lithium Battery Pack
Page 4–47 Traction and Reel Drive System: Service and Repairs
Figure 48) onto the shaft,
Figure 48), support
Replacing the Reel
Figure