Toro Greensmaster eFlex 1800 Service Manual page 257

Installing the Groomer Cover (Counter Rotating Groomer Drive) (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g228146
1. Shaft
C. Slide shaft up through bore of cover and secure with thrust washer and
retaining ring. Position shaft in cover so that the cam point of shaft is
located away from the gasket surface
D. Install plunger detent into groomer cover so that the end of plunger if from
flush to 0.5 mm (0.020 inch) extending from cover surface
E. Slide handle into shaft so that it extends toward the front of the cover.
F. Apply Loctite #242 (or equivalent) to threads of set screw. Install set
screw into end of shaft to secure handle in place.
2. Install groomer cover assembly to right drive plate assembly
A. Ensure that the handle on groomer cover is rotated toward the front of
the machine.
B. Fill groomer cover with approximately 142 g (5 fl oz) of Mobil XHP221
grease (or equivalent).
C. Install new gasket and then groomer cover assembly to right drive plate.
Secure cover with 5 flange-head screws.
3. Connect the battery pack; refer to
(page 8–3).
Figure 188
2. Cam point
(Figure
Connecting the Lithium Battery Pack
Page 8–9 Belt Driven Groomer: Service and Repairs
3. Plunger detent
188).
(Figure 188).
(Figure 186):