Toro Greensmaster eFlex 1800 Service Manual page 267

Disassembling the Grooming Reel (continued)
Assembling the Grooming Reel
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. Remove grooming reel from cutting unit; refer to
Reel (Forward Rotating Groomer Drive) (page 8–10)
Grooming Reel (Counter Rotating Groomer Drive) (page
2. Remove locknut from either end of the shaft
If grooming reel is equipped with carbide tipped blades, note
position of blades on groomer shaft as they are removed. Correct
direction of blades is required for proper groomer operation.
3. Remove spacers and blades from groomer shaft as necessary.
1. Start by placing thick spacer against the locknut installed on one end of
groomer shaft. Then, place first blade against installed spacer
If groomer is equipped with blades with carbide tips, ensure that the
blades are installed with the tips in the same, correct direction.
2. For 1.3 cm (1/2 inch) blade spacing, ensure there are 2 blade spacers
between blades (Figure
3. When all blades have been installed, place second thick spacer on shaft and
then thread second locknut onto the shaft.
g228297
1. Locknut
4. Position locknuts to allow blades and spacers to be centered on the shaft
(Figure 199); torque locknuts to 23 to 28 N∙m (200 to 250 in-lb) so that
the spacers are not free to rotate.
5. Install grooming reel back onto cutting unit; refer to
Reel (Forward Rotating Groomer Drive) (page 8–12)
Grooming Reel (Counter Rotating Groomer Drive) (page
IMPORTANT
IMPORTANT
198).
Figure 199
2. Center blades on shaft
Page 8–19
Removing the Grooming
or Removing the
8–14).
(Figure 198).
(Figure
3. Grooming shaft
Installing the Grooming
or Installing the
8–16).
Belt Driven Groomer: Service and Repairs
198).