Toro Greensmaster eFlex 1800 Service Manual page 134

Adjusting the Parking Brake Latch Switch
Electrical System: Adjustments
1. Park the machine on a level surface and place the traction lever in the
N position. Turn the key switch to the O
EUTRAL
key from the key switch.
2. Disconnect the battery pack; refer to
(page 5–7).
g202426
1. Parking brake latch switch
2. Washer-head screw (2 each)
3. Locknut (2 each)
4. Washer-head screw (4 each)
3. Remove the console cover from the handle to get access to the parking
brake latch switch
4. Raise the parking brake lever and engage the parking brake latch.
5. With the parking brake latch engaged, there should be 0.0 to 2.2 mm (0.000
to 0.090 inch) clearance between the latch and the parking brake latch switch
(Figure 83).
6. If the clearance is incorrect, loosen the brake latch switch mounting fasteners,
adjust the clearance, and tighten the fasteners. Check the clearance
between the lever and switch after you tighten the fasteners. The parking
brake latch should rotate freely past the switch.
7. After adjusting the parking brake latch switch, install the console cover to
the handle.
8. Connect the battery pack; refer to
(page 5–7).
Connecting the Lithium Battery Pack
Figure 84
5. Console cover
6. Lower handle
7. Switch panel
(Figure 84).
Connecting the Lithium Battery Pack
Page 5–34
position and remove the
FF
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E