Toro Greensmaster eFlex 1800 Service Manual page 64

Removing the Drum Drive Belt (continued)
Installing the Drum Drive Belt
Traction and Reel Drive System: Service and Repairs
4. Rotate the traction engage/disengage lever to the disengaged position to
remove tension from the drum drive belt; refer to
from the Transmission (page
5. Remove the 7 washer-head screws (item 1 in
drum drive cover, and remove the cover to expose the drum drive system.
6. Remove and discard the gasket (item 17 in
housing.
7. Remove the retaining ring (item 3 in
to the brake clevis pin. Slide the brake band from the brake clevis and brake
mount pins, and remove the band from the drum drive housing.
8. Carefully remove 1 end of the extension spring (item 4 in
anchor point and rotate the spring away from the drive belt.
g203651
1. Traction drive belt
2. Drive pulley
9. Pivot the idler pulley away from the drum drive belt to loosen the belt tension
(Figure 29).
10. Remove the drum drive belt from the drive pulley and then from the
differential pulley.
1. Ensure that the battery pack is disconnected; refer to
Battery Pack (page
2. Place the drum drive belt onto the differential pulley and then fit the belt to
the drive pulley. Ensure that the belt is on the rear side of the idler pulley.
3. Carefully install removed end of the extension spring (item 4 in
the anchor point.
4. Install the brake band over brake surface of the differential pulley. Slide
the ends of the brake band onto the brake clevis and brake mount pins.
Secure the brake band to the brake clevis pin with the retaining ring (item
3 in Figure 28).
4–4).
Figure
Figure 29
3. Idler pulley
4. Differential pulley
4–3).
Page 4–22
Disengaging the Drum Drive
Figure 28) that secure the
Figure 28) from the cover and
28) that secures the brake band
Figure 28) from
5. Brake band
Connecting the Lithium
Figure
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
28) to