Toro Greensmaster eFlex 1800 Service Manual page 159

Testing the Sensor (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
4. If the EZ turn sensor LED did not function correctly:
A. Ensure that the EZ turn sensor is properly adjusted (refer to the Operator's
Manual). If necessary, adjust the sensor and return to step
B. Ensure that the key switch is O
connector from the machine wire harness.
C. Turn the key switch to the S
then turn the key switch to the R
g202574
1. Terminal A
D. Connect the multimeter common (-) test probe to the harness connector
terminal C (black wire) and second test probe to the harness connector
terminal A (pink wire)
harness connector has 12 VDC circuit voltage present.
E. If the sensor connector has circuit voltage present and sensor LED
did not function, replace the EZ turn sensor. Adjust the sensor after
installation (refer to the Operator's Manual).
5. After you complete the EZ turn sensor testing, plug the sensor connector into
the machine wire harness.
6. Connect the battery pack; refer to
(page 5–7).
and then disconnect the EZ turn sensor
FF
position to wake up the machine and
TART
position.
UN
Figure 109
2. Terminal C
(Figure 109). Check with the multimeter that the
Connecting the Lithium Battery Pack
Page 5–59 Electrical System: Testing the Electrical Components
4 above.
3. Terminal B