Toro Greensmaster eFlex 1800 Service Manual page 259

Removing the Grooming Reel (Forward Rotating Groomer Drive) (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
3. Remove the cutting unit from the machine and place cutting unit on a flat
work area.
4. Remove groomer drive cover (item 2 in
from groomer drive; refer to
Groomer Drive) (page
5. Loosen 2 bolts (item 10 in
groomer arms.
g228151
1. Front roller bolt
2. Grooming reel assembly
g228149
1. Drive pulley
2. Idler pulley
6. Remove locknut (item 13 in
groomer arm lift rod to drive plate assembly
7. Remove HOC nut (item 21 in
secure right groomer arm assembly to drive plate assembly. Do not change
height-of-cut screw adjustment. Remove right groomer arm assembly from
cutting unit.
8. Remove front roller assembly from cutting unit.
Note: To prevent grooming reel shaft from turning when removing driven
pulley, use wrench on shaft flats to hold shaft.
9. Remove the locknut (item 1 in
grooming reel shaft. Remove driven pulley from shaft.
Figure
Replacing the Groomer Belt (Forward Rotating
8–6).
Figure 189) that secure front roller shaft to
Figure 190
3. Locknut
4. Spring washer
Figure 191
3. Driven pulley
4. Right drive plate assembly
Figure 189) and spring washer that secure right
Figure 189), HOC washer, and plow bolt that
Figure 189) that secures driven pulley to
Page 8–11
189) and groomer drive belt
5. Groomer arm lift rod
5. Groomer drive belt
(Figure 190).
Belt Driven Groomer: Service and Repairs