Toro Greensmaster eFlex 1800 Service Manual page 59

Removing the Reel Drive Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Disconnect the battery pack; refer
to Connecting the Lithium Battery Pack (page
g203645
1. Telescoping coupler
2. Slide the telescoping coupler off the cutting unit hex shaft
3. Remove the reel drive belt; refer to
4. Loosen the 2 set screws (item 11 in
pulley (item 18 in Figure
driveshaft. Locate and retrieve the woodruff key from the shaft.
5. Remove the washer-head screw (item 9 in
drive housing to the cutting unit side plate.
Note: The 2 hex nuts (item 24 in
cutting unit production. The nuts must remain in cutting unit side plate during
the reel drive housing removal.
6. Remove the 2 flange-head screws (item 20 in
drive housing to the cutting unit side plate.
7. Remove the reel drive assembly from the cutting unit.
8. Remove the components from the reel drive housing as necessary
25).
9. If the idler shaft ball bearings (item 8 in
press to remove the bearings and the bearing spacer from the shaft. Discard
the bearings after removal.
Note: Refer to Reel Drive Bearing Housing (page 4–19)
assembly information of bearing housing assembly (item 2 in
Note: The reel pulleys (items 12, 18, and 19 in
color and number of teeth. The location of pulley can vary based on desired
cutting unit clip frequency; refer to
Figure 26
2. Cutting unit hex shaft
Reel Drive Belt (page
Figure
25) to the reel driveshaft. Slide the pulley from the
Figure 25) have adhesive applied during
Figure
Adjusting the Cutting Unit Clip (page
Page 4–17 Traction and Reel Drive System: Service and Repairs
FF
4–3).
(Figure
4–14).
25) that the secure the reel
Figure 25) that secures the reel
Figure 25) that secure the reel
25) are to be removed, use a
for disassembly and
Figure
Figure 25) can be identified by
position,
26).
(Figure
25).
4–10).