Toro Greensmaster eFlex 1800 Service Manual page 60

Installing the Reel Drive Assembly
Traction and Reel Drive System: Service and Repairs
1. Install all the components that were removed to the reel drive housing
25). If the ball bearings (item 8 in
shaft, use a press to install new bearings and the bearing spacer onto the
shaft.
2. Apply a light coating of grease on the reel drive housing O-rings (items 4
and 23 in Figure 25).
3. Position the reel drive assembly to the cutting unit. Ensure that the spring pin
(item 26 in Figure 25) and compression spring are positioned between the
reel drive housing and the bearing housing assembly.
4. Secure the reel drive assembly with the 2 flange-head screws (item 20 in
Figure 25) and washer-head screw.
5. Install the woodruff key to the reel driveshaft (item 21 in
anti-seize lubricant at the top of the key.
6. Slide the reel pulley (item 18 in
contacts the shoulder on the shaft. Secure the reel pulley with the 2 set
screws; torque the set screws to 8.3 to 8.9 N∙m (74 to 79 in-lb).
7. Install the reel drive belt; refer to
the reel drive cover is secured to the housing after the belt installation.
8. Slide the telescoping coupler onto the cutting unit hex shaft
9. Connect the battery pack; refer to
(page 4–3).
Figure 25) were removed from the idler
Figure 25) onto the reel driveshaft until it
Reel Drive Belt (page
Connecting the Lithium Battery Pack
Page 4–18
Figure 25). Apply
4–14). Ensure that
(Figure
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
(Figure
26).