Toro Greensmaster eFlex 1800 Service Manual page 239

Assembling the Roller (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g206894
1. Seal
2. Assembly spacer
8. Position an assembly spacer and yellow assembly washer (refer to
Rebuilding Tools (page
Thread the nut onto each end of the shaft.
9. Tighten each nut until the yellow assembly washers bottom out against the
roller housing. Remove the nuts, assembly washers, and assembly spacers
from the roller shaft.
10. Lubricate the lips of installed seals with #2 grease.
11. Carefully slide a dry V-ring onto each bearing locknut. The V-rings should
be installed without any lubrication.
Note: If original bearing locknut(s) are being used, apply Loctite #242 (or
equivalent) to the threads of the locknut(s).
12. Install the bearing locknut with V-ring onto each end of the roller shaft; torque
the locknuts to 34 to 41 N∙m (25 to 30 ft-lb).
Figure 175
3. Yellow assembly washer
4. Bearing locknut
2–18)) on each end of the roller shaft
Page 7–25
Roller
(Figure 175).
Cutting Unit: Service and Repairs