Toro Greensmaster eFlex 1800 Service Manual page 91

Removing the Reel Clutch Shaft (seized bearing condition)
(continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
The ball bearing will be damaged during this procedure. Remove the
ball bearing from the reel clutch shaft and discard the bearing after
the shaft has been removed from the housing; refer to
Reel Drive System (page 4–43)
4. Clean and inspect the bearing bore in the housing. If damage is severe in the
housing, replace the transmission housing.
5. Use a 1/4 inch-20 UNC tap to install threads in the 2 holes drilled in the
transmission housing.
6. Install the 2 1/4 inch-20 bolts with flat washers into the tapped holes in the
transmission housing. The bolts not longer than 3/8 inch in length should be
used. After you install the bolts, ensure that the ends of the bolts do not
extend into the ball bearing bore in the housing.
7. Service the reel clutch shaft assembly as necessary; refer to
Reel Drive System (page
on the reel clutch shaft.
8. Install the reel clutch shaft assembly into the transmission housing and
assemble the transmission; refer to
4–43).
IMPORTANT
for bearing removal information.
4–43). Ensure that the new ball bearing is installed
Transmission Reel Drive System (page
Page 4–49 Traction and Reel Drive System: Service and Repairs
Transmission
Transmission