Assembling the Roller (continued)
Cutting Unit: Service and Repairs
g206892
1.
Pack with grease
2.
Seal
5. Apply a coating of grease to the nut surface to prevent the seal damage
during seal installation
6. Carefully install the seals onto the bearing locknuts. Pack the back of the
seal 75 to 90% full with #2 grease
g206893
1.
Seal
7. Install a nut with seal onto each end of the roller shaft. Tighten the nuts
until they bottom against bearings
roller shaft.
Figure 173
3.
Grease nut surface
4.
Bearing locknut
(Figure
173).
(Figure
173).
Figure 174
2.
Bearing locknut
(Figure
174). Remove the nuts from the
Page 7–24
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E