Toro Greensmaster eFlex 1800 Service Manual page 264

Removing the Grooming Reel (Counter Rotating Groomer Drive) (continued)
Installing the Grooming Reel (Counter Rotating Groomer Drive)
Belt Driven Groomer: Service and Repairs
g228293
1. Roller bolt
2. Grooming reel assembly
9. Remove locknut and spring washer that secure right groomer arm lift rod to
right drive plate assembly
10. Remove HOC nut (item 2
secure right groomer arm assembly to right drive plate assembly. Do
not change height-of-cut screw adjustment. Remove right groomer arm
assembly from cutting unit.
11. Remove front roller from cutting unit.
Note: To prevent grooming reel shaft from turning when removing driven
pulley, use wrench on shaft flats to hold shaft.
12. Remove the locknut (item 15 in
grooming reel shaft. Remove driven gear from shaft.
Note: To prevent cutting unit from turning when removing groomer drive gear,
use a 1/2 inch socket on hex of reel driveshaft that is used for backlapping
the cutting unit.
13. Loosen and remove groomer drive gear (item 17
cutting unit shaft.
14. Remove 4 button-head screws (item 30 in
drive plate assembly to the support plate on the cutting unit frame. Remove
the right drive plate assembly from grooming shaft and cutting unit.
15. Carefully pull the grooming reel from the left support plate.
16. Inspect seals, bushings, and bearings in right drive plate, left support plate
and groomer arms for wear or damage. Also, inspect gears and idler
components for wear or damage. Replace components as necessary.
1. Apply a light coating of grease to ends of grooming reel shaft and also to
seal lips in right drive plate and left support plate. Ensure that all bearings,
bushings, and seals are properly installed.
2. Ensure that the O-ring (item 11 in
shaft. Apply light coating of grease to O-ring.
3. Carefully place grooming reel assembly into the left support plate taking care
to not damage seal in support plate or O-ring on shaft.
Figure 195
3. Locknut
4. Spring washer
(Figure 195).
Figure 192), HOC washer, and plow bolt that
Figure 192) that secures driven gear to
Figure
Figure 192) is installed on grooming reel
Page 8–16
5. Groomer arm lift rod
inFigure 192) from the
192) that secure the right
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E