Toro Greensmaster eFlex 1800 Service Manual page 144

Accessing the Fuse
Testing the Fuse
Electrical System: Testing the Electrical Components
Do not open the lithium battery pack. With the exception of the
battery pack fuse, fuse cover, and labels, there are no consumer
serviceable parts on or in the battery pack. If you open the battery
pack, you will void the warranty. The battery pack is protected by
tamper-alerting devices.
1. Park the machine on a level surface and place the traction lever in the
N position. Turn the key switch to the O
EUTRAL
key from the key switch.
2. Disconnect the battery pack; refer to
(page 5–7).
3. Raise and support the battery pack to get access to the fuse cover; refer to
Lithium Battery Pack (for Models 04042, 04043, and 04046) (page
4. Remove the 8 screws and 8 lock washers that secure the fuse cover to the
bottom of the battery pack
5. After you complete the fuse service:
A. Secure the fuse cover to the bottom of the battery pack with the 8 screws
and 8 lock washers
B. Lower and secure the battery pack to the machine; refer to
Battery Pack (for Models 04042, 04043, and 04046) (page
C. Connect the battery pack; refer to
(page 5–7).
1. Access the battery pack fuse as described above.
2. Carefully remove the fuse from the battery pack fuse holder for testing.
3. The fuse should have continuity between the fuse terminals.
The fuse used in the lithium battery pack is a very fast acting 58 V
fuse. If the battery pack fuse replacement is necessary, ensure to
use the fuse as identified in your eFlex Parts Catalog.
4. Carefully install the functional fuse into the fuse holder.
5. Install the fuse cover and connect the battery pack as described in step 5.
IMPORTANT
Connecting the Lithium Battery Pack
(Figure 94). Remove the fuse cover.
(Figure 94); torque the screws to 0.34 N∙m (3 in-lb).
Connecting the Lithium Battery Pack
IMPORTANT
Page 5–44
position and remove the
FF
Lithium
5–74).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
5–74).