Toro Greensmaster eFlex 1800 Service Manual page 136

Adjusting the Traction Switch
Electrical System: Adjustments
1. Park the machine on a level surface and place the traction lever in the
N position. Turn the key switch to the O
EUTRAL
key from the key switch.
2. Disconnect the battery pack; refer to
(page 5–7).
g202428
1. Engagement lever assembly
2. Lower handle
3. Console cover
4. Washer-head screw (4 each)
3. Remove the console cover from the handle to get access to the traction
switch (Figure 86).
4. Move the traction engagement lever forward to the engaged position.
5. With the traction engagement lever in the engaged position, there should be
0.8 to 3.0 mm (0.030 to 0.120 inch) clearance between the head of the bolt in
the traction lever and the traction switch
Note: With the traction lever pushed fully forward against its rotation stop,
the head of the bolt should not deflect the traction switch more than 0.8 mm
(0.030 inch). The traction lever will rotate back slightly once latched. At that
point, the required clearance (0.030 to 0.120 inch) should be maintained.
6. If the clearance is incorrect, loosen the traction switch mounting fasteners,
adjust the clearance, and tighten the fasteners. Check the clearance
between the bolt head and switch after tightening the fasteners. The bolt
head must not contact the switch.
7. After adjusting the traction switch, install the console cover to the handle.
8. Connect the battery pack; refer to
(page 5–7).
Connecting the Lithium Battery Pack
Figure 86
5. Washer-head screw (2 each)
6. Traction switch
7. Locknut (2 each)
8. Switch mount bracket
(Figure
Connecting the Lithium Battery Pack
Page 5–36
position and remove the
FF
85).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E