Toro Greensmaster eFlex 1800 Service Manual page 205

Disassembling the Traction and Reel Drive Engagement Lever Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the switch. Disconnect the battery pack; refer to
Connecting the Lithium Battery Pack (page
g198905
1. Reel engage switch
2. Switch mount bracket
3. Traction lever assembly
4. Spring
5. Flange-head screw (4 each)
6. Shifter bracket
7. Flange nut (4 each)
2. Remove the console cover from the handle to get access to the traction
lever assembly (Figure
3. Disconnect the reel clutch cable from the traction lever assembly; refer to
Replacing the Reel Clutch Cable (page
away from the traction lever assembly.
4. Disconnect the wire harness connectors from the traction and reel engage
switches (Figure 141).
5. Disconnect the spring (item 4 in
control with the traction lever assembly.
6. Remove the 4 flange-head screws (item 5 in
that secure the traction lever assembly and brackets to the handle. Remove
the assembly (including lever assembly, shifter bracket, shift mount, and
switch mount bracket) from the handle.
7. Remove the 2 flange-head screws (item 13 in
that secure the switch mount bracket and shift mount to the shifter bracket.
Separate the brackets to allow disassembly of the traction lever assembly.
8. Disassemble the traction lever assembly
the orientation of the end hooks on all the springs for assembly purposes.
Figure 141
8. Lower handle
9. Screw (4 each)
10. Console cover
11. Shift mount
12. Traction switch
13. Flange-head screw (2 each)
14. Flange nut (2 each)
141).
6–10). Position the end of the cable
Figure 141) that connects operator presence
(Figure 140
Page 6–15 Chassis and Controls: Service and Repairs
FF
6–3).
Figure 141) and 4 flange nuts
Figure 141) and 2 flange nuts
and Figure 141). Note
position,