Toro Greensmaster eFlex 1800 Service Manual page 226

Installing the Bedbar (continued)
Cutting Unit: Service and Repairs
g206882
1. Metal washer
2. Bedbar
3. Cutting unit side plate
4. Locknut
5. Position the bedbar into the cutting unit. Ensure that the top of each bedbar
arm is between the washer (item 11 in
flange.
6. Position a metal washer and a plastic washer between the bedbar and each
cutting unit side plate
7. Install the bedbar pivot bolt assemblies. Ensure that the plastic washers are
not caught on the threads of the pivot bolts. Torque each bedbar pivot bolt
to 22 to 27 N∙m (190 to 240 in-lb).
8. Tighten both the locknuts (item 17 in
have any endplay but still can be rotated. Do not overtighten the locknuts as
this can distort the side plates and affect the reel bearing adjustment. When
the locknut is correctly tightened, there may be a gap at the inside washers.
9. Tighten the locknut (item 9 in
until the adjuster spring is fully compressed, then loosen the locknut 1/2 turn.
When adjusting the bedknife to cutting unit, ensure that the contact
is as light as possible to lengthen the amount of work the machine
will perform on each charge.
10. Adjust the cutting unit; refer to the Cutting Unit Operator's Manual.
11. Install the cutting unit to the machine.
12. After all necessary adjustments have been made, connect the battery pack;
refer to Connecting the Lithium Battery Pack (page
Figure 160
5. Bedbar pivot bolt
6. Nylon bushing
7. Plastic washer
8. Rubber bushing
Figure
(Figure 160).
Figure
Figure 159) on each bedbar adjuster assembly
IMPORTANT
Page 7–12
159) and the adjuster screw
159) until outside washers do not
7–3).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E