The Gear Box Assembly - Toro Greensmaster eTriFlex 3360 Service Manual

The Gear Box Assembly

g285625
1. Gear box assembly
2. Drive shield
3. Cotter pin
Removing the Gear Box Assembly
Universal Groomer (Optional): Service and Repairs
The groomer gear box assembly is located on the opposite side of the cutting
unit from the cutting unit motor. The groomer gear boxes for eTriFlex machines
are installed on the right side of the cutting unit.
Refer to Figure 178 for this procedure.
1. Remove the cutting unit from the machine and place it on a level work
surface.
2. Remove the groomer reel assembly; refer to
(page 8–14).
3. Remove the drive shield, or, if the cutting unit is equipped with an optional
powered rear roller brush, remove the rear roller brush drive assembly to
service the groomer drive; refer to
4. Install a 5/16–18 X 5/8 inch square head set screw (Toro p/n 1-803022) in the
end of the drive shaft and tighten to 13 N·m (120 in-lb); refer to
5. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the groomer gear box. Discard the cotter pin.
6. Tip up the cutting unit to access the bottom of the reel to remove the drive
shaft assembly.
Figure 178
4. Clevis pin
5. Input shaft
Rear Roller Brush (Optional) (page
Page 8–4
Removing the Groomer Reel
Figure
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
7–30).
179.