Toro Greensmaster eFlex 1800 Service Manual page 72

Installing the Traction Drum (continued)
Traction and Reel Drive System: Service and Repairs
g203653
1. Grease seal
8. If a grease seal (item 28 in
drum, install a new grease seal into the drum. Ensure that the seal lip is
orientated toward the center of the drum. Press the seal into the drum bore
so that the seal is recessed from 12.0 to 13.4 mm (0.470 to 0.530 inch)
from edge of the drum
9. Place the square key into the slot of the drum shaft. Apply anti-seize lubricant
to the top surface of the key.
10. Align the slot in the left traction drum with the key on the drum shaft and
carefully slide the traction drum onto the shaft, ensure that you do not
damage the grease seal in the drum.
11. Insert a bar stock or other suitable tool through the spokes of the left traction
drum to keep the drum from turning.
12. Ensure that the ball bearing (item 19 in
bearing nut. While retaining the left drum, secure the drum to the traction
drum assembly with a bearing nut. Torque the bearing nut to 102 to 122
N∙m (75 to 90 ft-lb).
13. Secure the left side plate to the machine
A. Slide the left side plate onto the supporting bearing.
B. Secure the left side plate to the frame with the 3 flange-head screws
and 3 hardened washers.
C. Secure the left side plate to the rear frame with the carriage screw,
hardened washer, and flange nut.
14. Install the handle assembly to the machine; refer to
6–4). Ensure that all the cable adjustments are correct.
15. Install the rail kit wheels if they were attached; refer to
(Optional) (page 6–24).
16. Install the transport wheels if they were attached; refer to
(Optional) (page 6–21).
17. Connect the battery pack; refer to
(page 4–3).
Figure 35
2. Left traction drum
Figure 33) was removed from the left traction
(Figure 35).
Figure
(Figure
Connecting the Lithium Battery Pack
Page 4–30
33) is pressed onto the
34) as follows:
Handle Assembly (page
Rail Kit Wheels
Transport Wheels
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E