Toro Greensmaster eFlex 1800 Service Manual page 213

Disassembling the Transport Wheel (continued)
Assembling the Transport Wheel
Installing the Transport Wheel
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
6. If necessary, remove the shoulder screws, torsion spring, and retaining lever
from the hub.
1. If the shoulder screws were removed from the hub, apply Loctite #242 (or
equivalent) to the threads of the shoulder screws. Secure the torsion spring
and retaining lever to the hub with the shoulder screws.
2. Assemble the tire, tube, and deep rim.
3. Install the shallow rim into the tire. Align and secure the shallow rim to the
deep rim with the 4 bolts (item 12 in
the fasteners.
4. Install the hub into the deep rim. Secure the hub to the deep rim with the 3
bolts (item 1 in Figure
5. Inflate the tire to 83 to 103 kPa (12 to 15 psi).
1. Ensure that the machine is parked on a level surface and the key is removed
from the key switch.
2. Support the machine on the kickstand.
3. Slide the transport wheel completely onto the wheel hex shaft until the wheel
retaining lever is secured into the groove on the wheel hex shaft.
Figure
146) and 3 lock washers. Tighten the fasteners.
Page 6–23 Chassis and Controls: Service and Repairs
146) and 4 flange nuts. Tighten