Toro Greensmaster eFlex 1800 Service Manual page 33

Angle Indicator and Magnetic Mount
Angle Indicator: Toro Part No. 131–6828
Magnetic Mount: Toro Part No. 131–6829
Because the top grind angle on bedknives is critical for edge
retention, and therefore after− cut appearance, Toro has
develop these service tools for accurately measuring the top
grind angle on all bedknives.
Since there can be variations in the mounting surface of the
bedbar, it is necessary to grind the bedknife after installing
it to the bedbar.
1. Place the angle indicator on the bottom side of the
bedknife with the digital display facing you as shown.
2. Press the Alt Zero button on the angle indicator.
3. Remove the angle indicator and place the magnetic mount
on the edge of the bedknife so the face of the magnet is flat
against the top angle of the bedknife.
4. Place the angle indicator on the mount with the digital
display facing you as shown. The angle displayed on the
indicator is the current bedknife top angle.
Bedknife Screw Tool
Toro Part No. TOR510880
This screwdriver-type bit is made to fit Toro bedknife
attaching screws. Use this bit with a torque wrench to secure
the bedknife to the bedbar.
IMPORTANT
Important: To prevent damage to the
bedbar, DO NOT use an air or manual
impact wrench with this tool.
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. Bedknife
2. Angle Indicator
1. Angle indicator surface
2. Magnetic mount
3. Bedknife
Page 2–17 Specifications and Maintenance: Special Tools
g223327
Figure 8
3. Bedbar
g223326
Figure 9
4. Bedbar
5. Angle indicator