Installing the Reel Drive Belt
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
1. Ensure that the battery pack is disconnected; refer to
Battery Pack (page
2. Use a 16 mm (5/8 inch) wrench, rotate and hold the bearing housing to allow
the reel drive belt installation
3. Place a new drive belt onto the pulleys.
4. Release the bearing housing to apply tension to the reel drive belt. Ensure
that the bearing housing rotates freely which allows accurate belt tension.
5. Rotate the reel drive at least 1 full turn to ensure that the drive belt is properly
tensioned.
6. Tighten the bearing housing mounting nut
7. Install the reel drive cover to the machine and secure the cover with the
flange-head screw
8. Connect the battery pack; refer to
(page
4–3).
4–3).
(Figure
24).
(Figure
23).
Connecting the Lithium Battery Pack
Page 4–15
Traction and Reel Drive System: Service and Repairs
Connecting the Lithium
(Figure
24).