Toro Greensmaster eFlex 1800 Service Manual page 170

Removing the Electric Motor (continued)
Installing the Electric Motor
Electrical System: Service and Repairs
5. Remove the 2 flange-head screws (item 7 in
electric motor to the transmission.
6. Carefully slide the electric motor from the transmission, and remove the
motor from the machine.
7. Remove and discard the O-ring (item 6 in
the motor.
1. Apply a light coating of grease to new O-ring (item 6 in
the O-ring to the flange of the electric motor.
2. Apply grease to the splines of the motor shaft.
3. Position the electric motor to the transmission, align the splines of the motor
shaft to the transmission coupler, and insert the motor shaft into the coupler.
Slide the motor fully to the transmission surface.
4. Secure the electric motor to the transmission with the 2 flange-head screws;
torque the screws to 29 to 33 N∙m (21 to 25 ft-lb).
5. Connect the electric motor connections to the machine wire harness.
6. Connect the battery pack; refer to
(page 5–7).
Figure
Connecting the Lithium Battery Pack
Page 5–70
Figure 118) that secure the
118) from the flange of
Figure 118). Install
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E