Toro Greensmaster eFlex 1800 Service Manual page 99

Removing the Transmission
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g203645
1. Telescoping coupler
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Disconnect the battery pack; refer
to Connecting the Lithium Battery Pack (page
2. Disconnect the reel clutch cable from the transmission; refer to
the Reel Clutch Cable (page
3. Slide the telescoping coupler off the cutting unit hex shaft
4. Remove the right drum drive cover and drive belt from the machine; refer to
Drum Drive Belt (page
5. Remove the electric motor from the machine; refer to
5–69).
6. Remove the battery pack from the machine; refer to
Battery Pack (page
7. Remove the 4 washer-head screws (item 8 in
extension housing to the right drum housing.
8. Support the transmission to prevent it from falling.
9. Remove the fasteners that secure the transmission to the machine frame.
A. The flange-head screw (item 2 in
transmission to the frame.
B. The bolt (item 13 in
that secure the rear of the transmission to the frame.
10. Carefully move the transmission assembly toward left side of the machine
until the extension housing is clear of right drum housing. Lift the transmission
from the machine.
11. To disassemble the transmission, refer to
4–38), Transmission Idler System (page
System (page 4–43),
Transmission Drum Drive System (page
Figure 57
2. Cutting unit hex shaft
6–10).
4–21).
5–74).
Figure
Figure 56), hardened washer, and flange-head screw
Transmission Drive Belt (page
4–41),
Transmission Drive System (page
4–53).
Page 4–57 Traction and Reel Drive System: Service and Repairs
FF
4–3).
Replacing
(Figure 57).
Electric Motor (page
Removing the Lithium
Figure 56) that secure the
56) that secures front of the
Transmission Reel Drive
4–50), and
position,