Toro Greensmaster eFlex 1800 Service Manual page 84

Disassembling the Transmission Idler System
Assembling the Transmission Idler System
Traction and Reel Drive System: Service and Repairs
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Disconnect the battery pack; refer
to Connecting the Lithium Battery Pack (page
2. Remove the transmission drive belt; refer to
Drive Belt (page 4–39).
3. Disassemble the idler system as necessary
bearings if they are removed from the idler pulleys.
4. Check the bushings (items 2 and 6 in
Replace the bushings if necessary. The bushings for engage/disengage
shaft are pressed into the transmission housing and cover.
1. Assemble the idler system as necessary
support the idler pulleys are pressed into the pulleys.
A. If the bearings were removed from the idler pulleys, press new bearings
fully to the shoulder of the idler pulleys.
g205732
1. Engage/disengage shaft
2. Idler pulley
3. Transmission belt
B. If the extension spring was removed, ensure that the ends of the spring
are orientated as shown in
C. If the main drive idler (item 13 in
to the transmission housing with the shoulder screw; torque the shoulder
screw to 21 to 23 N∙m (15 to 17 ft-lb).
D. After securing the idler components to the transmission housing, ensure
that all the idler pulleys rotate smoothly.
2. Install the transmission drive belt and all the machine components removed
for the idler system service; refer to
3. Connect the battery pack; refer to
(page 4–3).
Figure
(Figure
Figure 47
4. Main drive idler
5. Extension spring
Figure 47.
Figure 46) was removed, secure the idler
Transmission Drive Belt (page
Connecting the Lithium Battery Pack
Page 4–42
FF
4–3).
Removing the Transmission
(Figure 46). Discard the ball
46) for wear or damage.
46). The ball bearings that
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position,
4–38).