Toro Greensmaster eFlex 1800 Service Manual page 138

Adjusting the Reel Engage Switch
Electrical System: Adjustments
1. Park the machine on a level surface and place the traction lever in the
N position. Turn the key switch to the O
EUTRAL
key from the key switch.
2. Disconnect the battery pack; refer to
(page 5–7).
g202430
1. Engagement lever assembly
2. Lower handle
3. Console cover
4. Washer-head screw (4 each)
3. Remove the console cover from the handle to get access to the reel engage
switch (Figure 88).
4. Move the engagement lever forward to the cutting unit engagement position.
5. With the engagement lever in the cutting unit drive engagement position,
there should be 0.8 to 2.2 mm (0.030 to 0.090 inch) clearance between the
tab on the cutting unit engagement lever and the reel engage switch
87).
6. If the clearance is incorrect, loosen the reel engage switch mounting
fasteners, adjust the clearance, and tighten the fasteners. Check the
clearance between the lever tab and the switch after tightening the fasteners.
The tab on the cutting unit engagement lever must not contact the switch.
7. After adjusting the reel engage switch, install the console cover to the handle.
8. Connect the battery pack; refer to
(page 5–7).
Connecting the Lithium Battery Pack
Figure 88
5. Washer-head screw (2 each)
6. Locknut (2 each)
7. Reel engage switch
8. Switch mount bracket
Connecting the Lithium Battery Pack
Page 5–38
position and remove the
FF
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
(Figure