Toro Greensmaster eFlex 1800 Service Manual page 265

Installing the Grooming Reel (Counter Rotating Groomer Drive) (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
4. Apply light coating of grease to O-ring on right drive plate assembly pivot hub
and pilot bore of cutting unit side plate.
5. Carefully slide right drive plate onto grooming reel shaft taking care to not
damage seals in drive plate. Position drive plate to the support plate on the
cutting unit frame and secure with 4 button-head screws (item 30 in
192). Ensure that the drive plate rotates freely after installation.
6. Install driven gear (item 14 in
A. Apply light coating of grease to hub on driven gear.
B. Carefully slide driven gear onto the grooming reel shaft taking care to not
damage seal in drive plate.
Note: To prevent grooming reel shaft from turning when installing driven
gear, use wrench on shaft flats to hold shaft.
C. Secure gear to shaft with locknut (item 15 in
to 24 to 28 N∙m (17 to 21 ft-lb).
Note: To prevent cutting unit from turning when installing groomer drive gear,
use a 1/2 inch socket on hex of reel driveshaft that is used for backlapping
the cutting unit.
7. Secure groomer drive gear (item 17 in
gear to 170 N∙m (125 ft-lb).
8. Install the 2 idler gears (43T and 47T) to right drive plate assembly
194). Secure gears with flange nuts and torque flange nuts 13.5 N∙m (120
in-lb).
9. Install extension spring to right drive plate assembly
10. Insert front roller into left groomer arm assembly.
11. Ensure that the bushing (item 3 in
plate assembly.
12. Apply anti-seize lubricant to threads of right groomer arm lift rod.
13. Position right groomer arm assembly to front roller, right drive plate, and
cutting unit frame. Secure groomer arm to cutting unit with plow bolt (item 31
in Figure 192), HOC washer, and HOC nut.
14. Secure right groomer arm assembly to drive plate with spring washer (item 4
in Figure 192) and locknut.
15. Center front roller to cutting unit and tighten bolts (item 7 in
secure roller.
16. Fill groomer cover with approximately 142 g (5 fl oz) of Mobil XHP221 grease
(or equivalent). Install new gasket and then groomer cover assembly to
right drive plate; refer to
(page 8–7).
17. Check grooming reel height and mower height-of-cut settings. Adjust as
necessary.
18. Install cutting unit to the machine.
19. Lubricate groomer bearings; refer to
20. Connect the battery pack; refer to
(page 8–3).
Note: After greasing groomer bearings, operate groomer for 30 seconds,
stop machine, and wipe excess grease from groomer shaft and seals.
Figure 192) onto grooming reel shaft:
Figure
Figure 192) is installed in right drive
Groomer Cover (Counter Rotating Groomer Drive)
Installation Instructions (page
Connecting the Lithium Battery Pack
Page 8–17
Figure 192); torque locknut
192) to cutting unit shaft; torque
(Figure 193).
Figure
Belt Driven Groomer: Service and Repairs
Figure
(Figure
192) to
8–2).