Toro Greensmaster eFlex 1800 Service Manual page 202

Removing the Reel Clutch Cable (continued)
Installing the Reel Clutch Cable
Chassis and Controls: Service and Repairs
g198903
1. Shift handle
2. Reel cable spring
4. Remove the reel clutch cable from the traction lever assembly
as follows:
A. Loosen the bottom cable jam nut that secures the reel clutch cable to the
shift mount bracket on the handle. Slide the cable from the bracket.
B. Remove the cable spring from the spring anchor on the traction lever
assembly. Note the orientation of the cable spring hook on the traction
lever assembly for assembly purposes.
5. Remove the reel clutch cable from the machine.
1. Secure the reel clutch cable to the traction lever assembly
follows:
A. Install the cable spring to the spring anchor on the traction lever assembly.
Orientate the cable spring hook end toward front of the machine.
B. Slide the cable housing into the shift mount bracket slot. Ensure that a jam
nut, flat washer, and lock washer are on both sides of the bracket. Adjust
the jam nuts so that equal amount of cable threads are visible above and
below the jam nuts. Leave the jam nuts snug until final cable adjustment.
2. Route the reel clutch cable to the transmission and install the cable
138) as follows:
A. Secure the cable eyelet to the transmission reel clutch lever with the
retaining ring.
B. Position the reel clutch cable to the casting slot of the transmission with a
jam nut, flat washer, and lock washer on each side of the slot.
C. Adjust and tighten the jam nuts to compress the cable spring to a length
from 70.6 to 72.4 mm (2.780 to 2.850 inches).
D. Remove the rubber plug at front of the transmission to view reel clutch.
Ensure that the reel clutch teeth disengage when the clutch is released.
Figure 139
3. Bottom cable jam nut
4. Top cable jam nut
Page 6–12
5. Reel clutch cable
6. Shift mount bracket
(Figure
(Figure
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
139)
139) as
(Figure