Toro Greensmaster eFlex 1800 Service Manual page 94

Assembling the Transmission Drive System (continued)
Traction and Reel Drive System: Service and Repairs
D. Install the set screw (item 8 in
tighten against the drive spline.
E. Secure the splined coupler in the driven pulley with the retaining ring
(item 4 in Figure
2. Install all the components that were removed onto the driven pulley (item
12 in Figure 53).
A. If the ball bearings (items 15 and 5 in
driven pulley, press the new bearings onto the pulley.
B. As necessary, install the flocked bearing shield (item 6 in
(flocked side orientated toward bearing location), wave spring, and flat
washer onto the driven pulley. Secure the components with the retaining
ring.
3. If the motor adapter (item 2 in
housing, secure the adapter to the housing with the 4 washer-head screws.
Tighten the screws as follows:
A. First, use an alternating crossing pattern, torque all the screws to 1.7 to
4.5 N∙m (15 to 40 in-lb).
B. Again use an alternating crossing pattern, torque all the screws to 9.6 to
10.7 N∙m (85 to 95 in-lb).
4. Slide the driven pulley assembly (including bearings) into the motor adapter.
5. Install the transmission drive belt and all the machine components removed
for the reel drive system service; refer to
4–38).
6. Fill the internal spline area of the splined coupler with high temperature Mobil
XHP-222 grease (or equivalent).
7. Install the electric motor to the transmission; refer to
5–69).
8. Connect the battery pack; refer to
(page 4–3).
Figure 53) into the end of the pulley and
53).
Figure
Figure 53) was removed from the transmission
Transmission Drive Belt (page
Connecting the Lithium Battery Pack
Page 4–52
53) were removed from the
Figure
Electric Motor (page
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
53)