Toro Greensmaster eFlex 1800 Service Manual page 177

Removing the Lithium Battery Pack (continued)
Installing the Lithium Battery Pack
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
8. Remove the 6 bolts (item 7 in
the battery pack to the battery base.
9. Carefully remove the battery pack from the battery base and the machine.
Do not open the lithium battery pack. With the exception of the
battery pack fuse, fuse cover, and labels, there are no consumer
serviceable parts on or in the battery pack. If you open the battery
pack, you will void the warranty. The battery pack is protected by
tamper-alerting devices.
1. Ensure that the battery base is raised and supported.
2. Carefully position the battery pack to the battery base. The battery connector
port should be toward the rear of the machine.
3. Secure the battery pack to the battery base with the 6 bolts (item 7 in
122) and 6 flat washers; torque the bolts to 11.3 to 14 N∙m (100 to 130 in-lb).
4. Connect the wire harness connector to the battery pack
follows:
A. Line up the tabs on the inside of the wire harness connector with the slots
in the battery pack receptacle and press the wire harness connector
into the battery pack receptacle.
B. Rotate the locking collar on the harness connector clockwise until it
engages with the battery pack receptacle and begins to pull in toward the
battery. Continue rotating the collar approximately 120° (1/3 of a turn)
until it fully seats.
When pivoting battery pack to the frame, ensure to not pinch the
wire harness between the machine components.
5. Remove the screwdriver or rod used to hold the battery base in the raised
position. Carefully pivot the battery base and battery pack to the machine
frame. Ensure that the wire harness is not pinched between the machine
components as you lower the battery.
6. Secure the rear of the battery base to the frame with the tall nut (item 3 in
Figure 122). Then, secure the front of the base to the frame by fully tightening
the 2 flange-head screws and 2 flange nuts.
7. Connect the battery wire harness 6-pin connector to the machine wire
harness (Figure 121).
8. Connect the battery pack; refer to
(page 5–7).
Figure 122) and 6 flat washers that secure
IMPORTANT
IMPORTANT
Connecting the Lithium Battery Pack
Page 5–77
(Figure 124) as
Electrical System: Service and Repairs
Figure