Toro Greensmaster eFlex 1800 Service Manual page 289

Installing the Gear Box Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
Contact with the reel or other cutting unit parts can result in personal
injury.
Use heavy gloves when handling the cutting unit.
2. Safely prevent the reel from rotating by blocking the cutting unit with a piece
of wood near one of the reel spiders.
The groomer gear box use a right-hand thread. Turn the input shaft
clockwise to install the gear box.
3. Install the gear box to the cutting unit as follows:
A. Apply medium strength threadlocker to the input shaft threads and turn
the input shaft clockwise until it is seated against the reel.
B. Install a new cotter pin and clevis pin and secure the height adjustment
rod to the front of the groomer gear box.
C. Tighten the input shaft to 136 to 149 N∙m (100 to 110 ft-lb).
4. Install the rear roller brush drive shield if previously removed.
5. Install the groomer reel assembly; refer to
9–13).
CAUTION
IMPORTANT
Installing the Groomer Reel (page
Page 9–9 Universal Groomer (Optional): Service and Repairs