Toro Greensmaster eFlex 1800 Service Manual page 209

Removing the Kickstand (continued)
Installing the Kickstand
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
Be careful when removing or applying tension from or to the torsion
spring of the kickstand.
The spring is under heavy load and may cause personal injury.
g198900
1. Kickstand (raised)
2. Torsion spring
3. Rear frame
3. Use a nut driver or small diameter pipe over the end of the torsion spring.
Push the torsion spring down and in to release the spring tension
145). Slide the torsion spring from the pin on the rear frame.
4. Remove the bolt (item 7 in
the left side of the kickstand to the rear frame.
5. Remove the kickstand from the machine.
6. If necessary, disassemble and remove the service position locking pin
assembly (items 3, 4, 5, and 6 in
1. Ensure that the machine is parked on a level surface and key is removed
from the key switch.
2. If the service position locking pin assembly (items 3, 4, 5, and 6 in
was removed from the rear frame, install removed locking pin components.
3. Position the kickstand inside the machine frame. Insert the bolt (item 7 in
Figure 144) through the rear frame, kickstand, and spacer. Thread the flange
nut on the bolt and tighten to secure the kickstand.
4. Slide the torsion spring onto the pin on the rear frame. Place the end of the
spring in the slotted hole in the bottom of the rear frame.
5. Pivot the kickstand up and hold against the frame stops. Use a nut driver
or small diameter pipe over the end of the torsion spring. Push the spring
end down and out to install the spring
CAUTION
Figure 145
4. Kickstand (lowered)
5. Locking pin
Figure 144), spacer, and flange nut that secure
Figure 144) from the rear frame.
(Figure
Page 6–19 Chassis and Controls: Service and Repairs
(Figure
Figure
145).
144)