Toro Greensmaster eFlex 1800 Service Manual page 148

Testing the Key Switch (continued)
Electrical System: Testing the Electrical Components
g190999
5. With the use of a multimeter (ohms setting), test the switch functions to
determine if continuity exists between the various terminals for each switch
position. The switch terminals are marked as shown in
circuitry of the key switch is shown in the
Check the continuity between the switch terminals.
Circuit Logic Table
Switch Position
O
FF
R
UN
S
TART
6. Replace the key switch if necessary.
7. After you complete the testing, connect the wire harness electrical connector
to the key switch.
8. Install the console cover to the handle
9. Connect the battery pack; refer to
(page 5–7).
Figure 99
Circuit Logic Table (page
(Figure
Connecting the Lithium Battery Pack
Page 5–48
Figure 99. The
Circuits
None
B+C+F, D+E
A+B+C
98).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
5–48).