Toro Greensmaster eFlex 1800 Service Manual page 195

Removing the Handle Assembly (continued)
g198897
1. Handle
2. Carriage screw (2 each)
3. Offset handle clamp
4. Carriage screw
5. Bushing (3 each)
Installing the Handle Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
6. Shoulder bolt
7. Rubber bumper
8. Handle retainer
9. Hairpin cotter
10. Side plate (left)
Note: The offset handle clamps on eFlex 2100/2120 machines are mounted
on the outside of the side plates
offset handle clamps are mounted on the inside of the side plates.
7. Remove the handle clamps from the handle assembly
A. Remove the carriage screws and flange nuts that secure the handle
clamps to the offset handle clamps.
B. Remove the flange nuts that secure the shoulder bolts at the bottom of
the handle clamps.
C. Remove the inner handle clamps. Leave the shoulder bolts and outer
handle clamps in place on the handle.
8. Remove the handle assembly from the machine.
1. Position the handle assembly to the outer handle clamps on the machine.
2. Fit the inner handle clamps to the handle assembly and secure with removed
fasteners (Figure 134). Adjust the handle height before you fully tighten
the fasteners.
Note: The handle is traditionally operated with the handle adjusted to the
maximum height.
Figure 134
11.
12.
13.
(Figure 134). On eFlex 1800 machines, the
Page 6–5
Flange nut
Handle clamp
Flange nut (3 each)
(Figure 134) as follows:
Chassis and Controls: Service and Repairs