Toro Greensmaster eFlex 1800 Service Manual page 291

Installing the Idler Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. If the shields, bearing, or bushing was removed from the idler arm, install
new components as follows:
A. Press the bushing into a groomer plate until the bushing is centered in
the idler arm bore.
B. Press the bearing into the idler arm so that the bearing contacts the
shoulder in idler arm bore and install the bearing retaining ring.
C. Install the bearing shields with flocked side of shield toward the bearing.
g201411
1. Adaptor
D. Check the idler arm orientation (left or right cutting unit) and insert the
stub shaft (item 10 in
through hole in the shaft to prevent shaft from rotating, tighten the flange
nut to 37 to 45 N∙m (27 to 33 ft-lb).
E. If the collar was removed from the idler arm, install the collar and tighten
to 33 to 41 N∙m (24 to 30 ft-lb).
2. Apply anti-seize lubricant to the outside diameter of the adaptor
Position the idler arm over the adaptor.
3. Apply Loctite to the 2 socket-head screws and secure the adaptor and idler
arm to the cutting unit side plate.
4. Install a new cotter pin and clevis pin and secure the height adjustment rod
to the front of the idler arm.
5. Install the electric motor to the cutting unit; refer to
Figure 220
Figure 219) through shields and bearing. Use the
Page 9–11 Universal Groomer (Optional): Service and Repairs
(Figure 220).
Electric Motor (page 5–69).