Toro Greensmaster eFlex 1800 Service Manual page 231

Removing the Bedbar Adjuster
Installing the Bedbar Adjuster
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
Note: The detent used on eFlex 2100/2120 is toward the center of the cutting
unit as shown in Figure
on the outside of the cutting unit crossmember
procedures are the same on all models.
1. Remove the locknut (item 4 in
from the bedbar adjuster screw.
2. Remove the bedbar; refer to
Note: The bedbar adjuster shaft (item 11 in
3. Unscrew the bedbar adjuster shaft from the bedbar adjuster screw.
4. Remove the retaining ring (item 8 in
adjuster shaft and remove the adjuster shaft from the cutting unit frame.
5. Inspect the flange bushings (item 10 in
plate and remove if necessary.
6. If the detent is damaged, remove it from the cutting unit side plate by
removing the bolt.
1. If the detent (item 1 in
cutting unit side plate with the bolt.
2. If the flange bushings (item 10 in
on the bushing to the slot in the frame and install the bushings in the cutting
unit side plates.
3. Slide the bedbar adjuster shaft (item 11 in
bushings in the cutting unit side plate. Secure the adjuster shaft with the
wave washer and retaining ring.
Note: The bedbar adjuster shaft has left-hand threads.
4. Apply anti-seize lubricant to the threads of the bedbar adjuster screw (item 7
in Figure 165) that fits into the adjuster shaft. Thread the bedbar adjuster
screw into the adjuster shaft.
5. Install the bedbar; refer to
6. Install the washer (item 6 in
onto the adjuster screw. Tighten the locknut on the each bedbar adjuster
assembly until the compression spring is fully compressed, then loosen the
locknut 1/2 turn.
7. Adjust the cutting unit; refer to the Cutting Unit Operator's Manual.
165. On eFlex 1800 cutting units, the detent is mounted
Figure 165), compression spring, and washer
Removing the Bedbar Adjuster (page
Figure
Figure
Figure 165) was removed, secure the detent to the
Figure 165) were removed, align the key
Installing the Bedbar (page
Figure 165), compression spring, and locknut
Page 7–17
(Figure 166). Cutting unit service
Figure 165) has left-hand threads.
165) and wave washer from the
165) in the cutting unit side
Figure 165) into the flange
7–11).
Cutting Unit: Service and Repairs
7–17).