Toro Greensmaster eFlex 1800 Service Manual page 273

Removing the Idler Assembly (Forward Rotating Groomer Drive) (continued)
Installing the Idler Assembly (Forward Rotating Groomer Drive)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g228305
1. Drive pulley
2. Idler pulley assembly
B. Remove idler components from drive plate as necessary
and Figure 207).
1. Assemble idler components to drive plate
Note: When properly installed, the idler bracket (item 4 in
pivot freely on pivot hub. Also, the idler pulley should move freely from side
to side on the idler bracket pin.
2. Install right drive plate assembly to right side of cutting unit; refer to
Reel (Forward Rotating Groomer Drive) (page
3. Check and adjust grooming reel height and mower height-of-cut settings.
4. When all adjustments have been completed, connect the battery pack; refer
to Connecting the Lithium Battery Pack (page
Figure 207
3. Driven pulley
4. Right drive plate assembly
(Figure 206
Page 8–25
5. Groomer drive belt
(Figure 206
and Figure 207).
Figure 206) should
8–10).
8–3).
Belt Driven Groomer: Service and Repairs
Grooming