Toro Greensmaster eFlex 1800 Service Manual page 109

Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
the InfoCenter display comes on-line, the key switch can be turned to the R
position and the machine will be ready for operation.
Run Process
Pushing the traction engagement lever forward closes the traction switch. This
closed switch is used as an input by the TEC which communicates to the electric
motor to engage. The motor rotation speed and thus traction speed is determined
by the speed control setting that is adjusted by the operator. Actual motor speed
is monitored by the TEC and motor controller so that as traction load changes
(e.g., moving up or down an incline) the motor can compensate as necessary.
Engaging the cutting unit with the engagement lever closes both the traction and
reel engage switches. The electric motor will be engaged with control of motor
speed handled by the TEC and motor controller based on the operator speed
setting and load on the machine.
The EZ turn feature of an eFlex machine is available when the cutting unit is
engaged and the EZ turn switch on the console is in the O
turning the machine with EZ turn engaged, the ground speed will be reduced as
the cutting unit is raised from the ground. Speed will increase as the cutting unit
is lowered back to the turf after turning has been completed. The EZ turn feature
is not active when the machine is in the T
RANSPORT
Page 5–9 Electrical System: Electrical System Operation
position. When
N
position.
UN