Toro Greensmaster eFlex 1800 Service Manual page 275

Disassembling the Idler Assembly (Counter Rotating Groomer Drive)
Assembling the Idler Assembly (Counter Rotating Groomer Drive)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
1. Park machine on level surface. Turn key switch to the O
remove key from the switch. Ensure that the traction lever is in the N
position. Engage parking brake.
2. Disconnect the battery pack; refer to
(page 8–3).
3. Ensure that the handle on groomer cover is rotated toward front of machine
so that the groomer drive is engaged.
4. Remove groomer cover assembly and gasket from machine; refer to
Groomer Cover (Counter Rotating Groomer Drive) (page
5. Remove right drive plate assembly from right side of cutting unit; refer to
Grooming Reel (Counter Rotating Groomer Drive) (page
6. Remove idler components from right drive plate as necessary
1. Assemble idler components to right drive plate
retaining ring is fully seated in groove of reel hub after assembly.
Note: When properly installed, the idler bracket (item 4 in
pivot freely on reel hub.
2. Install right drive plate assembly to right side of cutting unit; refer to
Reel (Counter Rotating Groomer Drive) (page
groomer drive gear and grooming reel driven gear are properly torqued. Do
not install idler gears, extension spring or groomer cover assembly to drive
plate assembly.
g228308
1. Idler bracket
2. Idler bracket stop
3. Check adjustment of adjustment cam
A. Rotate idler bracket so that the bracket stop is against the adjustment
cam.
B. While holding bracket stop against the cam, measure the distance
between the idler gear bearing surfaces on the idler bracket and the drive
plate. This distance should be 37.7 mm (1.484 inch).
C. If distance is incorrect, loosen flange nut that secures adjustment cam to
drive plate. Rotate the adjustment cam until distance is correct. Then,
tighten flange nut to secure adjustment. Ensure that the distance is still
correct after tightening the nut.
Connecting the Lithium Battery Pack
Figure 210
3. Adjustment cam
4. Idler bearing location
(Figure
Page 8–27
position and
FF
8–7).
8–14).
(Figure
(Figure 208). Ensure that the
Figure 208) should
8–14). Ensure that the
5. Plate bearing location
210):
Belt Driven Groomer: Service and Repairs
EUTRAL
208).
Grooming