Toro Greensmaster eFlex 1800 Service Manual page 87

Disassembling the Reel Clutch Shaft (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
2. Press the ball bearing (item 24 in
shaft. Discard the bearing that was removed.
3. Carefully remove the retaining ring (item 23 in
reel brake disc to the reel drive hub.
Note: Do not damage the brake disc friction material when removing the
retaining ring.
4. Remove the reel brake disc from the reel drive hub, note the orientation of
the disc for assembly purposes. The friction material side of the disc needs
to be positioned toward the reel brake ring (item 2 in
pressed into the transmission housing.
5. Slide the reel clutch hub (item 20 in
from the reel drive hub. For assembly purposes, note the correct orientation
of the indicator mark on the fork. If necessary, remove the pivot pins and
separate the fork from the hub.
g205734
1. Hub flat location
2. Reel clutch shaft
3. Bearing collar
6. Use a modified socket (refer to
bearing collar assembly from the clutch shaft
To prevent damage, avoid using excessive clamping pressure on
the reel clutch shaft assembly.
A. Use the flats on the reel drive hub to carefully secure the reel clutch shaft
assembly in a vise. Use a vise with soft jaws to prevent damage to the
clutch shaft assembly components.
B. Slide the modified socket over the bearing collar. Align the modified
socket so that the 5/32 inch pin can be inserted through the socket and
hole in the bearing collar.
C. Use a modified socket and socket wrench to remove the bearing collar
assembly from the clutch shaft.
7. Remove the retaining ring (item 9 in
flocked bearing shield from the bearing collar. For assembly purposes, note
the orientation of the flocked bearing shield.
8. Press the ball bearing (item 7 in
the bearing that was removed.
9. Slide the reel clutch pulley assembly and reel drive hub from the clutch shaft.
Figure 48) from the end of the reel clutch
Figure 48) and reel clutch fork assembly
Figure 50
4. Ball bearing
5. Flocked bearing seal
6. Wave spring
Special Tools (page
IMPORTANT
Figure
Figure 48) from the bearing collar. Discard
Page 4–45 Traction and Reel Drive System: Service and Repairs
Figure 48) that secures the
Figure 48) which is
7. Flat washer
8. Retaining ring
4–7)) to remove the
(Figure 50).
48), flat washer, wave spring, and