Toro Greensmaster eFlex 1800 Service Manual page 225

Removing the Bedbar (continued)
Installing the Bedbar
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
4. Tip the cutting unit to expose the bedknife. Support the rear of the cutting
unit; refer to Supporting the Cutting Unit when Servicing (page
5. Loosen the locknuts (item 9 in
adjuster assembly until the washer is loose.
6. Loosen the locknuts (item 17 in
7. Remove the 2 bedbar pivot bolts, 4 metal washers, and 4 plastic washers
from the cutting unit side plates.
Contact with the reel, bedknife, or other cutting unit parts can result
in personal injury.
Use heavy gloves when handling the bedbar.
8. Remove the bedbar assembly from the cutting unit.
9. Inspect the nylon bushings (item 15 in
in side plates for wear or damage. Remove the bushings and replace if
necessary.
1. If the rubber bushing was removed from either cutting unit side plate, apply
grease to the outside surface of new bushing and install into the side plate.
The bushing should flush with the inside of the side plate.
2. If removed, install the nylon bushings (item 15 in
facing outward. Apply anti-seize lubricant to the inside of flange bushing.
3. Apply anti-seize lubricant to the bedbar threads and the shoulder area of
each bedbar pivot bolt.
When installing the washers (items 7 and 6 in
that the plastic washers are positioned on either side of the cutting
unit side plate (Figure
4. Slide a metal washer (item 6 in
each bedbar pivot bolt.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury.
Use heavy gloves when handling the bedbar.
Figure 159) on the end of each bedbar
Figure 159) on each bedbar pivot bolt.
CAUTION
Figure
IMPORTANT
160).
Figure 159) and then a plastic washer onto
CAUTION
Page 7–11
7–2).
159) and rubber bushings
Figure 159) with flange
Figure 159), ensure
Cutting Unit: Service and Repairs