Toro Greensmaster eFlex 1800 Service Manual page 270

Removing the Grooming Reel Bearing (continued)
Installing the Grooming Reel Bearing
Belt Driven Groomer: Service and Repairs
6. Remove grooming reel seals and bearings from right drive plate and left
support plate assemblies
all removed seals and bearings.
g228303
1. Outer bearing
2. Drive plate shoulder
3. Inner bearing
1. Install new grooming reel bearings and seals into right drive plate and left
support plate assemblies
Bearings should be installed with extended inner races toward
center of housing. Also, apply pressure equally to inner and outer
bearing races when installing bearings.
A. Press new outer bearing fully to shoulder of right drive plate bore. Then,
install new inner bearing until inner race contacts outer bearing race.
B. Press new bearing into left support plate until it is flush with shoulder
of bearing bore.
C. Install new seals into groomer side plates.
Note: Seals should be installed so that the lip side of the seal will face
the center of the cutting unit. When bearings are greased, grease will
purge from inner seals.
2. Install left support plate to left side of cutting unit:
A. Apply anti-seize lubricant to threads of left groomer arm lift rod.
B. Position support plate to cutting unit making sure that left groomer arm lift
rod is positioned through bushing in support plate.
C. Place spring washer and locknut on lift rod threads
locknut.
D. Install reel drive assembly, reel pulley, reel drive belt and then reel drive
cover to left side of cutting unit; refer to
(Figure 202, Figure
Figure 205
4. Inner race
5. Seal lip
6. Support plate bearing
(Figure 205):
IMPORTANT
Reel Drive Assembly (page
Page 8–22
203, and Figure 204). Discard
7. Drive plate (right)
8. Support plate (left)
(Figure 201). Tighten
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
4–16).